Skip to content

AC adaptor for wireless handset of mobile telephone — electric shock risk

EU Safety GateSerious riskElectric shockDec 26, 2008

Hazard

The product poses a risk of electric shock because: - there is insufficient isolation between the parts connected to the mains and the output circuit which can be touched via the output cable, - creepage distances in the mains transformer (QYD 080310T1) between the primary and the secondary windings are less than 4 mm / 5 mm; measure a minimum of 0.2 mm between the primary winding and the output of the secondary winding, - there are no insulation tubes on the output wires, - the mains transformer does not pass the electric strength test of 3000 V AC for 1min between the primary winding and the secondary winding, - flash-over occurs at 1250 V AC. The product does not comply with the Low Voltage Directive and the relevant European standard EN 60950.

Measures taken

  • Recall from consumers ordered by the authorities — Other

Product description

Plug-in type AC adaptor for wireless handset of mobile telephone. Handset operates with Bluetooth mobile phones with USB connector.

What should I do?

If you own this product, stop using it and check the official notice for what the seller or authority advises (return, refund, repair or disposal). Measures listed here were reported by national authorities to the EU Safety Gate system.

Recent alerts in this category

See all →