Skip to content

Single Meter Sockets Recalled by Milbank Manufacturing Due to Fire and Electrocution Hazards

U.S. CPSCBurnsOct 15, 2009
Picture of Recalled Single Meter Socket
Picture of Recalled Single Meter Socket
Picture of Recalled Single Meter Socket Bridge
Picture of Recalled Single Meter Socket Bridge
Picture of Single Meter Socket
Picture of Single Meter Socket

Photos from the official notice: U.S. Consumer Product Safety Commission · image rights

Hazard

A short may occur while in use due to an incorrect bridge installed in the product, to which the meter clips are attached. If the manufacturing defect exists, all metal parts of the meter could create a shock or burns can occur if the cover is off and the meter socket is energized.

Remedy

Consumers should stop using the recalled product immediately and contact the electrical supply contractor who installed the sockets. Contractors will contact Milbank Manufacturing for a replacement or reimbursement. Milbank will contact all distributors and stores where the recalled product was sold.

Incidents & injuries

Three incidents have been reported of the unit shorting out. No injuries were reported.

Product description

The single meter 200 amp/4 terminal sockets are used for underground utility meter installations. The meter socket is 20 3/4 inches high by 9 inches wide and 4 1/2 inches deep with 1 meter position. It is used by the approving utility to mount their electric meter to measure how much electricity a residence uses. It can be used for an underground residential application. The recalled model number 9090 appears on the right or left side of the installed meter socket. If not installed, model numbers U9090-O or R9090-O will appear on the label on the outside of the box.

Sold on

Electrical supply distributors in N.Y., Pa., Vt. and Mass. and at local hardware stores in N.Y. from May 2009 through August 2009 for about $70.

Contact the company

For additional information, contact Milbank Manufacturing's Sales Engineer toll-free at (888) 537-0881 between the hours of 8 a.m. and 4 p.m. CT Monday through Friday, or visit the company's Web site at www.milbankmfg.com

What should I do?

Stop using the product and follow the remedy below. Contact the company for a refund, repair or replacement — recall remedies are free.

Recent alerts in this category

See all →